Qsc plx series |
Post Reply | Page 12> |
Author | |
4D
Old Croc Joined: 13 November 2008 Location: Winchester Status: Offline Points: 4257 |
Post Options
Thanks(0)
Posted: 21 February 2010 at 10:50pm |
Is it me or are they nasty sounding adding a kind of 8 bit graininess. Used three 3602's to drive lo mid, hi mid, high on the r4's and it sounded pants. Has anyone else had a similar experience.
|
|
DMZ. "The bass was intense. Girls were literally running up to stand next to the subs"
|
|
Spesh
Old Croc Joined: 15 July 2007 Location: Surrey Status: Offline Points: 1606 |
Post Options
Thanks(0)
|
Not me.
I have a 3002 driving low mid on Floodlights and it sounds fine.
|
|
Nick Sasquash
Young Croc Joined: 24 June 2006 Location: North West UK Status: Offline Points: 1408 |
Post Options
Thanks(0)
|
Was looking at these as an option to power my tops?
|
|
https://operationsoundsystemrecords.bandcamp.com/
https://www.facebook.com/OperationSoundSystem/ |
|
kedwardsleisure
Old Croc Joined: 20 January 2009 Location: Staffordshire Status: Offline Points: 4947 |
Post Options
Thanks(0)
|
Shouldn't have an 8-bit anything, they have switchmode PSU but linear output stage
|
|
Kevin
North Staffordshire |
|
norty303
Old Croc Joined: 18 August 2004 Location: Eastbourne Status: Offline Points: 8806 |
Post Options
Thanks(0)
|
Always very happy with my PLX's. Sure it wasn't grainess elsewhere in the system?
|
|
My laser stuff: Frikkin Lasers
|
|
trapz72
Registered User Joined: 11 June 2009 Location: Gateshead Status: Offline Points: 149 |
Post Options
Thanks(0)
|
+ 1 happy with plx, use them for tops. 1202 i think, qsc are always crystal clear, clean amps.
|
|
Tony Wilkes
Old Croc Joined: 02 August 2004 Location: West Midlands Status: Offline Points: 4840 |
Post Options
Thanks(0)
|
PLX's work like wire with gain for me. They even clip very nicely.
Tony |
|
massacre_sounds
Registered User Joined: 09 May 2007 Status: Offline Points: 206 |
Post Options
Thanks(0)
|
Another thumbs up for the PLX's, fantastic amps in my opinion.
|
|
4D
Old Croc Joined: 13 November 2008 Location: Winchester Status: Offline Points: 4257 |
Post Options
Thanks(0)
|
Hmm well seems that there might be a need to look elsewhere along the signal chain or indeed in the room itself. Some kind of upper low mid phase cancellation. Bringing the h mid and tweets up in the mix.. The search continues..
|
|
DMZ. "The bass was intense. Girls were literally running up to stand next to the subs"
|
|
fredos666
Registered User Joined: 11 October 2008 Status: Offline Points: 205 |
Post Options
Thanks(0)
|
I can confirm, I always found QSC amp a bit agressive...
|
|
Bob Lee (QSC)
Registered User Joined: 10 April 2009 Location: Costa Mesa, Cal Status: Offline Points: 59 |
Post Options
Thanks(0)
|
Unless it's defective, it wouldn't be adding anything. If the input signal is grainy, the output signal will be, too.
|
|
Bob Lee
Apps Engnr, QSC Audio Secretary, Audio Engineering Soc. |
|
4D
Old Croc Joined: 13 November 2008 Location: Winchester Status: Offline Points: 4257 |
Post Options
Thanks(0)
|
Hmmm
shop bought cd Cdj1000 drawmer sp2120 sw9088iis 3 x plx3602 2 x qscex4000 2 x fk1 f218 2 x fk1 res4scp On paper it should be sweet. Single stacked the 218's subs with the r4s flown each side so as I mentioned possibly its a placement issue. Have yet to have time to get back to the venue for another play.. |
|
DMZ. "The bass was intense. Girls were literally running up to stand next to the subs"
|
|
Post Reply | Page 12> |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |