XKitz "all in one" amp / bluetooth / bms |
Post Reply |
Author | |
bitSmasher
Old Croc Joined: 23 June 2012 Location: Melbourne Status: Offline Points: 2295 |
Post Options
Thanks(0)
Posted: 29 April 2017 at 6:18am |
I've followed XKitz for a while, as their products interest me... though I haven't had a need for any of it:
https://www.xkitz.com They've been posting on Instagram about an upcoming "all in one" module for portable bluetooth speakers, with details finally released: https://www.krowdster.co/l/e447 I'll copy/paste the blurb below. As I've posted in another thread, I'm playing with the Sure JAB2 and expect (& hope) the XKitz to be more of a premium option. JAB2 Discussion here: http://forum.speakerplans.com/sure-jab-2-all-in-one-amp-bluetooth-bms_topic96581.html Anyone else seen this, and what do you think? |
|
https://www.instagram.com/batteryacidsoundsystem/
|
|
bitSmasher
Old Croc Joined: 23 June 2012 Location: Melbourne Status: Offline Points: 2295 |
Post Options
Thanks(0)
|
PORTABLE SPEAKER INTEGRATED AMPLIFIER AND CONTROLLER
Combines all the functions of a portable Bluetooth speaker into one compact and tightly integrated module Bluetooth v4.2 Audio Front End Active Crossovers and DSP Audio Processor 2.1 Class-D amplifiers with 250W RMS combined power 250W Lithium-Ion power supply for fully wireless portable operation Power saving features to extend battery life All built on a compact plate module Designed and built for the highest possible audio quality Bluetooth streaming AAC format - not the low quality SBC format used by most Bluetooth speakers that gives Bluetooth audio a bad reputation Active Bi-Amped topology for the ultimate crystal clear audio - no need for expensive passive crossovers that only distort your sound and waste half of your battery power High Definition 24 bit/96KHz DSP audio processing Ultra low distortion Class-D amplifiers Audio Front End Bluetooth v4.2 with AAC streaming and up to 24bit/96KHz audio Analog line-level input with 24bit/96KHz sampling Active Crossovers and DSP Audio Processor Linkwitz-Riley Active Crossover User programmable audio parameters: Crossover frequency and gain Crossover roll-off: 24dB or 48dB 15 band EQ Time delay correction Baffle Step Compensation Compressor/Limiter to prevent the amplifier from ever going into clipping Optional audio enhancements like Spatializer and Dynamic Bass Boost Class D Amplifiers 250W combined power 2.1 Configuration – One center sub-woofer and two tweeter channels 125W RMS to the woofer 62W RMS to the tweeters TAS5611A Class-D Amplifier: 10Hz-80KHz Signal Bandwidth 0.03% THD+N >100dB SNR No fan needed Lithium-Ion Power Supply 250W 2-Phase DC/DC converter - steps up the 14.8V Lithium-Ion battery voltage to 24V-30V needed by the amplifier Integrated LiIon/LiPo charge controller Dynamic Voltage Scaling – automatically turns up the voltage when you crank the volume and the amplifiers need the extra power, then turns it back down when not needed to save battery life Multiple levels of electrical and thermal protection to prevent Lithium-Ion battery damage DSP User Programmability - Similar to mini-DSP For those intrepid souls who want to delve deeper into the DSP programming and configuration, we expose the programming interface to the DSP chip to allow you to use SigmaStudio from Analog Devices to customize the audio processing to support any specialized functions you need. SigmaStudio is a very simple drag and drop programming interface, no need for specialized DSP programming expertise. The DSP functions available are similar to those in the mini-DSP system. |
|
https://www.instagram.com/batteryacidsoundsystem/
|
|
carlosdelondres
Registered User Joined: 21 June 2012 Location: London Status: Offline Points: 243 |
Post Options
Thanks(0)
|
Looks good - just had an email from Sure saying they'll be releaseing a 'JAB3' with more power and DSP in the next 2-3 weeks...will be interesting to compare the specs ;)
|
|
lutkeveld
Young Croc Joined: 23 September 2013 Location: The Netherlands Status: Offline Points: 517 |
Post Options
Thanks(0)
|
Is there any more info in the mail? Sounds interesting
|
|
carlosdelondres
Registered User Joined: 21 June 2012 Location: London Status: Offline Points: 243 |
Post Options
Thanks(0)
|
nope, no more than the above. Will post back if I hear anything more...
|
|
mini-mad
Old Croc Joined: 13 July 2012 Location: london Status: Offline Points: 6903 |
Post Options
Thanks(0)
|
..all that at 10%THD?
|
|
If it sounds like a gorilla is trying to escape, turn it down.
|
|
carlosdelondres
Registered User Joined: 21 June 2012 Location: London Status: Offline Points: 243 |
Post Options
Thanks(0)
|
They sent me the brochure, the JAB3 looks quite interesting - same amp options as the JAB1/2, but with the DSP module, and a connector to integrate with a JAB1/2. So JAB1/2 with JAB 3 gives you all the input and power options (MPPT, 18650 3S BMS/holder, bluetooth and analogue inputs), with 4 channels of DSP. They have programming interfaces to use Sigma Studio gui for the dsp configuration. Should be pretty sweet. $34.90 for the 2x50w version apparently!
|
|
Padde298
Registered User Joined: 13 July 2011 Status: Offline Points: 52 |
Post Options
Thanks(0)
|
#following :-)
|
|
LOUDER!!! MO BASS
|
|
Edd Jordan
Young Croc Joined: 10 January 2008 Location: United Kingdom Status: Offline Points: 1364 |
Post Options
Thanks(0)
|
whats happening?
|
|
I do a sideline in ply wood wheels.
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |