"ODEP" crown macrotech |
Post Reply | Page <1 101112 |
Author | |
kedwardsleisure
Old Croc Joined: 20 January 2009 Location: Staffordshire Status: Offline Points: 4947 |
Post Options
Thanks(0)
|
Thats too high, must be under 10mV and in reality is usually less than 5. |
|
Kevin
North Staffordshire |
|
Bigbassguy
New Member Joined: 22 August 2022 Location: Caribbean Status: Offline Points: 6 |
Post Options
Thanks(0)
|
Strange enough it dropped to under 10 when warmed up.
|
|
Bigbassguy
New Member Joined: 22 August 2022 Location: Caribbean Status: Offline Points: 6 |
Post Options
Thanks(0)
|
What's the cause and should it be under 10 at start-up?
How can it be adjusted?
|
|
kedwardsleisure
Old Croc Joined: 20 January 2009 Location: Staffordshire Status: Offline Points: 4947 |
Post Options
Thanks(0)
|
it should always be under 10, it's servo controlled, not adjustable. So, there's a fault somewhere. If the ODEP voltages cannot be adjusted (the adjustment is quite sensitive and should only need a touch on the pot, if the pot is hard-over then there's definitely a fault), then a faulty odep circuit itself can cause an offset, because the circuit controls the ultimate output stage drive current.
Make sure the output modules are 100% ok before digging into the control & power boards.Even the little board on the back of the output terminals (MA5000VZ) forms part of the feedback loop as the output is sensed right there. |
|
Kevin
North Staffordshire |
|
Bigbassguy
New Member Joined: 22 August 2022 Location: Caribbean Status: Offline Points: 6 |
Post Options
Thanks(0)
|
I've adjusted odep to spec and the protect issue stopped.
The bridge mode not also work but channel A seems to have 12v under ratings. I've tested some FETS removed and the C8187-4 reads well one time and at another time it reads invalid. Discharged them and reads well on and off so I'm guessing the others are playing games also.
|
|
Post Reply | Page <1 101112 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |