Speakerplans.com Homepage
Forum Home Forum Home > Plans > Other plans
  New Posts New Posts RSS Feed - MT102 Construction
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

MT102 Construction

 Post Reply Post Reply
Author
Message
Andrew View Drop Down
Registered User
Registered User


Joined: 10 March 2004
Location: United Kingdom
Status: Offline
Points: 669
Post Options Post Options   Thanks (0) Thanks(0)   Quote Andrew Quote  Post ReplyReply Direct Link To This Post Topic: MT102 Construction
    Posted: 27 October 2004 at 5:46pm

Does anyone know how the slopnig sides of the MT102 are supposed to work?  Does one cut down one edge of the timber to a paper-thin edge, or does it start 60mm at the driver end, and finish at 18mm (the timber thickness) at the cabinet base, and the same by the middle section?

Back to Top
Dom View Drop Down
Old Croc
Old Croc


Joined: 25 February 2004
Location: United Kingdom
Status: Offline
Points: 1700
Post Options Post Options   Thanks (0) Thanks(0)   Quote Dom Quote  Post ReplyReply Direct Link To This Post Posted: 27 October 2004 at 6:52pm

I'd cut it with a 9.5 degree mitre on the end that meets the baffle and a 80.5 degree mitre on the end at the front of the cab.  Same angle, you just have to hold the piece at 90 degrees to the saw when you cut the 80.5 degree angle...

 

Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.047 seconds.