Low Qes design |
Post Reply | Page <12 |
Author | |
Surfdude
New Member Joined: 12 September 2014 Location: Aruba Status: Offline Points: 5 |
Post Options
Thanks(0)
|
I'll see what it will be. I can also bridge the amp to have enough voltage range and drive two 8 Ohms in parallel.
The 2+2 was measured at 1 Ohm, now only I wonder is if/in which way the Qes changes when using the two coils in series for the 4 Ohm...? I've been googling and thinking, but ain't sure yet (R changes, but the amount of wire/windings doesn't...). Also because I've found 3 different kind of answers: stays equal, doubles and quadruples... Any inputs?
|
|
_djk_
Old Croc Joined: 23 November 2004 Location: United States Status: Offline Points: 6002 |
Post Options
Thanks(0)
|
"I wonder is if/in which way the Qes changes when using the two coils in series for the 4 Ohm...?"
It doesn't change.
|
|
djk
|
|
Post Reply | Page <12 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |