x15 with 4590-16 and PDN.15BR40 |
Post Reply |
Author | |
winda
New Member Joined: 26 April 2015 Location: Germany Status: Offline Points: 2 |
Post Options
Thanks(0)
Posted: 26 April 2015 at 6:35pm |
Hello
together,
I’m interested in
building two x15's additionally for my two 21"-scoops. I’m planning to use the following parts:
Is this a good
supplement for my two scoops? Will these chassis
work in this cabinet? Will I need a
crossover for the PD? Thanks in advance |
|
krazyneil
Young Croc Joined: 06 December 2007 Location: Bolton ,lancs Status: Offline Points: 1206 |
Post Options
Thanks(0)
|
hi
to get the best out of those you need to run the cab active with a crossover point around 1k between the pd and the bms id suggest as a start point, you could go as low as 800hz maybe but youd have to see how that sounds when you build them
dont forget to sim the pd in the x15 cab to make sure you tuned right id think it would be ok down to 50hz ish , you should be able to tell when you sim it in bbpro or winsid
these should sound very good as ther both very good drivers, the bms is used in some of the most expensive pa speakers you can buy
good luck
|
|
GOD TOLD ME TO DO IT !!!!!
|
|
bass*en*mass
Old Croc Joined: 03 September 2009 Location: "unknown" Status: Offline Points: 4009 |
Post Options
Thanks(0)
|
1x 4590 would easily cover 2-3 15" reflex loaded mids. Get the passive Xover for them!
2236 horns load well below 800hz.. personally i would build 2x single 15" cabs and 2 Tops with the same 15"+HF, this way you have smaller, scalable cabs and you could play around with crossover points between both 15"s.. (2x 80-250, other 2x 80-800 for example) With such a complex setup i would advise getting a digital LMS (Berry DCX) to apply delays, limiters, EQ etc.! |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |