Speakerplans.com Homepage
Forum Home Forum Home > General > Electro Frying Forum
  New Posts New Posts RSS Feed - void kryo 5.5 / ram s4004 problem
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

void kryo 5.5 / ram s4004 problem

 Post Reply Post Reply Page  <12
Author
Message
Marko View Drop Down
Registered User
Registered User
Avatar

Joined: 28 January 2009
Location: CRO
Status: Offline
Points: 234
Post Options Post Options   Thanks (0) Thanks(0)   Quote Marko Quote  Post ReplyReply Direct Link To This Post Posted: 10 January 2014 at 10:11pm
how much W is the bulb?
Back to Top
ceharden View Drop Down
The 10,000 Points Club
The 10,000 Points Club
Avatar

Joined: 05 June 2005
Location: Southampton
Status: Offline
Points: 11010
Post Options Post Options   Thanks (0) Thanks(0)   Quote ceharden Quote  Post ReplyReply Direct Link To This Post Posted: 10 January 2014 at 11:36pm
Some power supplies won't behave when being tested using the lightbulb method.  When the amp draws current, the resistance of the lamp causes the supply Voltage to the power supply to drop and could cause it to 'brown out' and the power supply shuts down.  Current drops, supply Voltage rises, power supply turns back on and what you end up is a very expensive flashing light controller!
Back to Top
cravings View Drop Down
Old Croc
Old Croc
Avatar

Joined: 30 January 2007
Location: Ireland
Status: Offline
Points: 6301
Post Options Post Options   Thanks (0) Thanks(0)   Quote cravings Quote  Post ReplyReply Direct Link To This Post Posted: 11 January 2014 at 1:51am
i think it's a 100w bulb.
Back to Top
Marko View Drop Down
Registered User
Registered User
Avatar

Joined: 28 January 2009
Location: CRO
Status: Offline
Points: 234
Post Options Post Options   Thanks (0) Thanks(0)   Quote Marko Quote  Post ReplyReply Direct Link To This Post Posted: 11 January 2014 at 8:00am
what Chris said...
you can avoid this by using higer wattage bulb
but then you probably loose the point of the bulb, if something in the amp need to blow it will blow...
 
Back to Top
cravings View Drop Down
Old Croc
Old Croc
Avatar

Joined: 30 January 2007
Location: Ireland
Status: Offline
Points: 6301
Post Options Post Options   Thanks (0) Thanks(0)   Quote cravings Quote  Post ReplyReply Direct Link To This Post Posted: 22 September 2014 at 8:39pm
just to bring this back up.. this amp went on the shelf of mistrust since new years, but as i said above it's always worked in the workshop since then. but the other day did a freebie gig for the climate change picnic thing here, so figured i'd bring it and the martin w3s again for a test run. ran them as side fills, ran them hard on live music, amp didn't miss a beat all day.. so i'm going to assume something weird about the new years' venue's power supply was the cause of the weirdness.
Back to Top
cravings View Drop Down
Old Croc
Old Croc
Avatar

Joined: 30 January 2007
Location: Ireland
Status: Offline
Points: 6301
Post Options Post Options   Thanks (0) Thanks(0)   Quote cravings Quote  Post ReplyReply Direct Link To This Post Posted: 13 March 2017 at 6:44pm
hah. this amp has been on the shelf since then i think. today used it in the workshop as i was testing a crossover.. and it worked fine. shut it down, started it up and the power light started flashing.. googled it.. and found my own thread i'd completely forgotten about haha. sigh..

wow that was 3 years ago.. guess its' still an issue with this amp
Back to Top
kedwardsleisure View Drop Down
Old Croc
Old Croc
Avatar

Joined: 20 January 2009
Location: Staffordshire
Status: Offline
Points: 3838
Post Options Post Options   Thanks (0) Thanks(0)   Quote kedwardsleisure Quote  Post ReplyReply Direct Link To This Post Posted: 13 March 2017 at 8:08pm
it hasn't improved with age then, unlike alot of what comes from Spain.

There are 2 wire jumpers you can pull off to check if it's an output fault. The psu should run seperately from the output section. Discharge caps before reconnecting.

Edited by kedwardsleisure - 13 March 2017 at 8:10pm
K. Edwards Electronics Engineers

North Staffordshire

Back to Top
 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.