![]() |
Suggestions for above WSX |
Post Reply
|
| Author | |
Esc4pe
Registered User
Joined: 08 August 2021 Location: England Status: Offline Points: 167 |
Post Options
Thanks(0)
Quote Reply
Topic: Suggestions for above WSXPosted: 16 April 2025 at 3:39pm |
|
Looking for suggestions for tops to go above 12 x Martin WSX being used in a mono block. Am not looking to have a separate “kick” section. Ideally would love to implement the use of B&C DCX464 in this project! Have looked at MEH options but due to the wide dispersion of the current DIY options available this doesn’t fit with the arrangement. PM60s have been considered but have heard that they are quite thin sounding at the point they would meet the WSX.
Wanting to keep this DIY. Am aware this is much easier options to be obtained by second hand pro kit but there are reasons for this decision! If there are any good DIY 3 way noncoax top options to consider too am open to this. Any suggestions greatly appreciated!
|
|
![]() |
|
Contour
Young Croc
Joined: 03 March 2004 Status: Offline Points: 677 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 April 2025 at 4:09pm |
|
Xtro?
|
|
![]() |
|
Jan-2T
Registered User
Joined: 18 October 2024 Location: Belgium Status: Offline Points: 137 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 April 2025 at 4:14pm |
|
The PM-90 and PM-60 on diy forum use coax drivers, might be worth looking it up.
|
|
|
Music!
|
|
![]() |
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |