HELP!!! Sim & Plan Mod suggestions?????

 

I am getting ready to build a  MT122 however i want to build it to accommodate the specs using this 12" driver. I want the box to get me max fidelity & spl.  I just want to know if these drivers are going to work well and give a decent performance. doesnt have to be "the best", but, a decent to good is acceptable.

Parameter Value Unit/Notes Effective piston area (Sd) 545.44 cm2 Free air resonance (Fs)  52.6 Hz DC resistance (Re) 5.9 Ω Mechanical Q factor (Qms) 11.19   Electrical Q factor (Qes) .57   Total Q factor (Qts) .54   Voice coil inductance (Le) .46 mH/milli-Henrys Equivalent air volume (Vas) 77.1 Liters Moving mass (Mms) 49.6 Grams/Mmd + air load mass Suspension compliance (Cms) 184.53 µM/N/micro-Meters per Newton Force factor (Bl) 13.02 Tm/Tesla-Meters Sensitivity (SPLref) 97.0 dB/reference 8Ω/2.83Vrms

 

 

 

Then, here are specs for the compression driver i want to use

 

http://www.seleniumloudspeakers.com/site2004/catalogo/pdf/pro_driverfenolico_d305_new.pdf 

 

What size horn should i use? What kinda disperation angle? What modifcations would you suggest to optimize this cabinet?

 

Thanks

 

 

 

Will this driver work better in a reflex design like the X12?

 

thanks