amplifier protection fault? |
Post Reply |
Author | |
Tan-2
Registered User Joined: 29 April 2011 Location: Glasgow Status: Offline Points: 255 |
Post Options
Thanks(0)
Posted: 23 March 2020 at 1:42pm |
Most amplifiers have high rail voltages in there and if your not sure of how to service of repair it give it to a tech..
I'm a little backed up with repairs at the moment and would need to look up the circuit diagram to see what's going on..
|
|
Logic will get you from A to B. Imagination will take you everywhere.
|
|
Tan-2
Registered User Joined: 29 April 2011 Location: Glasgow Status: Offline Points: 255 |
Post Options
Thanks(0)
|
Have to tried the amp with no load and slowly turn it up to see if the protection circuit activates...
|
|
Logic will get you from A to B. Imagination will take you everywhere.
|
|
GC32
Registered User Joined: 10 March 2008 Location: Fife Status: Offline Points: 123 |
Post Options
Thanks(0)
|
hello
I looking for help with powersoft M series two channel amp. With a very low signal input it seems to operate ok. Slight increase in signal sends into protection and amp immediately shuts down with clip light showing. If anyone can help with some ideas or straightforward test / repair I would be grateful and able to have a go. Otherwise I would appreciate recommendations for professional service contact thanks |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |