Admark K30 |
Post Reply | Page <1 891011> |
Author | |
taurusty
Registered User Joined: 09 January 2007 Location: Jamaica Status: Offline Points: 473 |
Post Options
Thanks(0)
|
U lucky! There's one culprit here using a 430 for 2 ohm bass on all 4 channels!
|
|
levyte357-
Old Croc Joined: 27 July 2012 Location: UK, South East Status: Offline Points: 8128 |
Post Options
Thanks(0)
|
AD42 buyers, |
|
Global Depopulation - Alive and Killing.
|
|
smitske96
Young Croc Joined: 16 February 2016 Location: The Netherlands Status: Offline Points: 1085 |
Post Options
Thanks(0)
|
You can contact and buy from them directly.
|
|
smitske96
Young Croc Joined: 16 February 2016 Location: The Netherlands Status: Offline Points: 1085 |
Post Options
Thanks(0)
|
So I ordered two AD430 DSP's, will report back about my findings (eventually ).
|
|
vibes92
Registered User Joined: 25 January 2020 Location: united kingdom Status: Offline Points: 59 |
Post Options
Thanks(0)
|
ad42 or the powersoft x8 (if money was not an issue?)
|
|
taurusty
Registered User Joined: 09 January 2007 Location: Jamaica Status: Offline Points: 473 |
Post Options
Thanks(0)
|
X8.
AD 42 does not have DSP, 6 extra channels and until I see a reputable review, honest power. A number of them have power supply issues here. |
|
levyte357-
Old Croc Joined: 27 July 2012 Location: UK, South East Status: Offline Points: 8128 |
Post Options
Thanks(0)
|
If money was not an issue, many say the X4L, is the daddy sub amplifier right now. Many have stated, X8, is not optimal for sub on all channels.
|
|
Global Depopulation - Alive and Killing.
|
|
csg
Old Croc Joined: 17 September 2007 Location: bedford Status: Offline Points: 6086 |
Post Options
Thanks(0)
|
No at 2 ohms per channel maybe, at 8ohms per channel it certainly doesn’t have an issue, and at 4 you will be running out of power supply puff if really pushing it
Im still to meet a sub driver that can’t be destroyed in rapid time with a x4 or x8 channel, the X4L is a monster and if you want to run lots of cabs per channel down long cables it can make sense, but personally I’d rather have the flexibility of those other 4 channels After all 8 channels is quite a few, a sound near me runs 2 X8’s, but the whole system( 4 scoops, 4 18”kicks, 2 2x12 mids, 2 2” horns and 2 4 way bullet boxes) runs at full chat on 5 channels of just one of the amps quite happily. It is normally configured across 7 channels with 2 sub and 2 bass. The second amp is for future expansion or as a spare. Its quite formidable now, 8 scoops on both amps is going to be scary…
Edited by csg - 11 January 2023 at 3:31pm |
|
“The fact is this is about identifying what we do best and finding more ways of doing less of it better”
|
|
MarjanM
Old Croc Joined: 10 February 2005 Location: Macedonia Status: Offline Points: 7810 |
Post Options
Thanks(0)
|
X4 and X8 @1600W/8ohm is not nearly enough for any high power 18. They are not enough for some of higher powered tops out there. I never understood why powersoft killed the K series without a proper replacement.
Yeah there is the X4L but i can buy a new car for that money. And yeah, a customer of mine had 4 of those blow up their PSUs running our subs last summer. So... go be a smart one and figure out where to put your money these days.
|
|
Marjan Milosevic
MM-Acoustics www.mm-acoustics.com https://www.facebook.com/pages/MM-Acoustics/608901282527713 |
|
csg
Old Croc Joined: 17 September 2007 Location: bedford Status: Offline Points: 6086 |
Post Options
Thanks(0)
|
It’s more than enough for any of mine thank-you, more than enough.
My largest subs RMS limit at 80V, peak at 170. Standard X4/8 channel does that with ease.
|
|
“The fact is this is about identifying what we do best and finding more ways of doing less of it better”
|
|
vibes92
Registered User Joined: 25 January 2020 Location: united kingdom Status: Offline Points: 59 |
Post Options
Thanks(0)
|
see iv hurd a few sounds using x8 and admark and they both sound good, i did prefer the x8 though in my opinion
|
|
smitske96
Young Croc Joined: 16 February 2016 Location: The Netherlands Status: Offline Points: 1085 |
Post Options
Thanks(0)
|
@vibes92
Which Admark was used, and could you explain the difference between the two? I have a pair of the AD430 and am just curious. |
|
Post Reply | Page <1 891011> |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |