12" Sub Build With BMS12N630 |
Post Reply | Page <12 |
Author | |
vertx
Young Croc Joined: 14 March 2012 Location: Sydney Status: Offline Points: 578 |
Post Options
Thanks(0)
|
Hopefully sort the grille out for the sub in the next few weeks to complete the build.
Currently paired up with a fun active 3-way HiFi I got to build for a mate
The tops have a very special 3D printed port ;) |
|
JonB67
Young Croc Joined: 22 April 2016 Location: UK Status: Offline Points: 1376 |
Post Options
Thanks(0)
|
Fantastic work vertx.
If it sounds as good as it looks you're onto a winner. Let us know your feedback on the hypex plate amps too.
|
|
infrasound
Old Croc Joined: 13 May 2011 Location: Brizzle Status: Offline Points: 2276 |
Post Options
Thanks(0)
|
So.. what's this "special" port?
|
|
vertx
Young Croc Joined: 14 March 2012 Location: Sydney Status: Offline Points: 578 |
Post Options
Thanks(0)
|
The flare ratio is based on the Comsol paper TG posted a while back. It sounds good.
Edited by vertx - 23 September 2021 at 9:47am |
|
vertx
Young Croc Joined: 14 March 2012 Location: Sydney Status: Offline Points: 578 |
Post Options
Thanks(0)
|
I've got about 10-12 of em floating round in mostly studio monitors and hifi I've built for mates. The first batch of em felt like they had almost a 40% failure rate but they swapped everything out which was annoying but not a big deal. Prices have raised since then, guessing it's gone into better QC as the new ones don't fail. I've got ones still working in cabinets that have been dropped so hard the tweeter has come out. If they had FIR they'd be killer. Not sure about em on PA use tho, haven't tried. Only had time to do some basic time/phase stuff, I'll finish up the EQ before I hand em over :)
30cm and 65cm measurements merged, no smoothing Same but with psychoacoustic smoothing |
|
vertx
Young Croc Joined: 14 March 2012 Location: Sydney Status: Offline Points: 578 |
Post Options
Thanks(0)
|
The grille for the sub is on it's way thanks to Markie
Plus I downloaded the latest version of REW and got stuck into the EQ on the mains. Frequency response from 0 - 40 degrees at 1m seems pretty much flat now within +-3db. I didn't bother taking much time to EQ anything under 300hz as there's no way to guarantee the measurements are good, but everything above that looks good. The SBAcoustics 4" NRX2 mids are great for the cost, running 300hz to 3khz here. Frequency response on-axis with psychoacoustic smoothing Same with Var smoothing and no smoothing |
|
toastyghost
The 10,000 Points Club Joined: 09 January 2007 Location: Manchester Status: Offline Points: 10920 |
Post Options
Thanks(0)
|
Although it’s not great to judge from a single trace in unknown conditions, if you do an average of measurements ~30 degrees around the listening position and still see the dip at 45 Hz, you might want to look into a limp mass absorber on the wall opposite to the normal orientation of the speakers.
|
|
Post Reply | Page <12 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |