Ta 2400 Help! |
Post Reply |
Author | |
BeAnTeK
Registered User Joined: 31 October 2020 Status: Offline Points: 21 |
Post Options
Thanks(0)
Posted: 31 May 2022 at 1:34am |
Hi there just tryna figure out how to run my void v18 1000
On my ya 2400 in bridge mode am unsure what I need to switch and/or re-wire. Any help would be greatly appreciated. Many thanks
|
|
BeAnTeK
Registered User Joined: 31 October 2020 Status: Offline Points: 21 |
Post Options
Thanks(0)
|
Also would running this amp in bridge mode be okay for this driver as at 8 ohm it chugs out 2300watts just don’t wanna cook anything.
|
|
BigSoundNorthWest
Registered User Joined: 29 November 2014 Location: Manchester Status: Offline Points: 290 |
Post Options
Thanks(0)
|
You'll need to switch it to bridge mode first,
Then, input into channel A. Output. Pin 1+ is 1+ (red post) on Ch A Pin 1- is 1 - (red post) on Ch B. |
|
BigSoundNorthWest
Registered User Joined: 29 November 2014 Location: Manchester Status: Offline Points: 290 |
Post Options
Thanks(0)
|
Yes as long as you watch the input signal for getting too high, you should have miles of headroom for the driver.
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |