t amp ta2400 in parallel mode |
Post Reply |
Author | |
davidhodgson
Registered User Joined: 16 December 2008 Status: Offline Points: 17 |
Post Options
Thanks(0)
Posted: 23 August 2009 at 2:39pm |
hi
if we put our tamp 2400 in parallel mode and connect 2 peavey ul18,s (8 oms each) to each speaker output will this be ok .the manual says it runs at 8 ohms in bridge /parallel mode.
obviously this will only be in mono but thats ok for subs.
many tx
|
|
levyte357
The 10,000 Points Club Joined: 10 May 2004 Location: UK, London Status: Offline Points: 11743 |
Post Options
Thanks(0)
|
Parallel mode just means one signal applied to both channels. This is not a quality sub amp, like qsc, crown, crest, so I would'nt drive it into clipping if you value your speakers. |
|
"Who am I? I'm the guy who does his job.. You must be the other guy".
|
|
davidhodgson
Registered User Joined: 16 December 2008 Status: Offline Points: 17 |
Post Options
Thanks(0)
|
tx for reply
but what ohmage will the amp be running at
in the manual it says 8 ohms bridge mode
the speakers are both 8 ohm cabs so what will the amp see
|
|
Timebomb
Old Croc Joined: 11 October 2004 Location: Lancaster Status: Offline Points: 2716 |
Post Options
Thanks(0)
|
4 ohms per channel.
As far as impedance is concerned its that same as running the amp in stereo mode. Parallel mode just means splitting the input signal and feeding it to both channels. Each channel has 2 x 8ohm speakers connected so each channel is seeing 4 ohms. |
|
James Secker facebook.com/soundgearuk
James@soundgear.co.uk www.soundgear.co.uk |
|
davidhodgson
Registered User Joined: 16 December 2008 Status: Offline Points: 17 |
Post Options
Thanks(0)
|
tx
sorry for confusion there will be only 1 8 ohm speaker connected per channel
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |