outline t6.5 /powersoft digam7000 service manual |
Post Reply | Page 123 7> |
Author | |
noobsound
Registered User Joined: 28 March 2008 Location: Romania Status: Offline Points: 67 |
Post Options
Thanks(0)
Posted: 05 October 2009 at 10:50am |
Hello. I am obout to buy a outline t6.5 amp ,basicaly a powersoft digam 7000 amp. I need a service manual or some schematics of the amp especialy of the power suply module. All fuses are ok but the amp is dead. Thx in advanced
|
|
DjLeco
Young Croc Joined: 21 April 2009 Location: Bucharest Status: Offline Points: 817 |
Post Options
Thanks(0)
|
I tried to fix it, but without schematics, I can't do anything.
The amp is very dirty inside, I checked all fuses, are OK, also Mosfets, and diodes from powersupply part of SMPS and PFC, are OK...
After bridge rectifier I have 310 volts, it looks the command part of smps , doesn't work.
|
|
I'm A Stupid SMART Romanian...
|
|
axeman91
Registered User Joined: 24 May 2007 Status: Offline Points: 249 |
Post Options
Thanks(0)
|
I think the schematics are in the back of the manual for the digam 7000 are they not?
|
|
Basil
Registered User Joined: 05 July 2009 Location: Lemberg Status: Offline Points: 18 |
Post Options
Thanks(0)
|
Write the address and I will send the scheme
|
|
noobsound
Registered User Joined: 28 March 2008 Location: Romania Status: Offline Points: 67 |
Post Options
Thanks(0)
|
Thx verry much Basil my adress is: noobsound@yahoo.com
|
|
CelsoSC
New Member Joined: 10 December 2007 Location: Portugal Status: Offline Points: 4 |
Post Options
Thanks(0)
|
Hello,
Switch on and see if you have +18V at your mainswitch and GND. If not, double check the 100mA fuse and the small transformer near the fan. See also if you have +15V at the 7815 Regulator. Had some troubles with the standby supply. Kind regards |
|
miguelplus
New Member Joined: 21 October 2009 Location: peru Status: Offline Points: 1 |
Post Options
Thanks(0)
|
fredos666
Registered User Joined: 11 October 2008 Status: Offline Points: 205 |
Post Options
Thanks(0)
|
Me too please...
|
|
alabpro
Registered User Joined: 25 August 2006 Location: Thailand Status: Offline Points: 33 |
Post Options
Thanks(0)
|
Hello... Me too please... For powersoft digam7000 service manual a_pracha@hotmail.com |
|
Basil
Registered User Joined: 05 July 2009 Location: Lemberg Status: Offline Points: 18 |
Post Options
Thanks(0)
|
All interested persons can take the scheme noobsound@yahoo.com
|
|
dannyavila
Registered User Joined: 08 March 2009 Location: Venezuela Status: Offline Points: 97 |
Post Options
Thanks(0)
|
Hello Noob...
I've repaired almost a dozen of this power amps that fractured the cooper trace closer to the Logic Circuit transformer's contacts, which has nothing to keep it tighten to the PS board but its own contact legs. Remove it and you'll probably find immediately the cracked cooper trace below its footprint.
Cheers!
|
|
Danny Avila.
Tech Service Manager Inaudio Servicios Integrales. |
|
DjLeco
Young Croc Joined: 21 April 2009 Location: Bucharest Status: Offline Points: 817 |
Post Options
Thanks(0)
|
I.m on charge to rapair it, can U put some pictures of that zone?
The amp is purely dead!
|
|
I'm A Stupid SMART Romanian...
|
|
Post Reply | Page 123 7> |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |