6th order BP kick section |
Post Reply | Page <12 |
Author | |
lukam
Registered User Joined: 15 April 2009 Location: Slovenia Status: Offline Points: 46 |
Post Options
Thanks(0)
|
Exactly! I'm trying to make the boxes as small as possible and use the unused space. I know that the driver selection is going to be the key. So what driver do you think would be the best? One with heavier or lighter cones. I'm afraid that the cone will break if its to weak (lighter cones). Maybee a rcf LF15n401 or MB15N351. The MB would be more efficient but dont know what will happen with the cone at higher volumes. When I get the horns and driver I have some measurement gear and will measure everything. I have already some P.audio SN-12b lying here. |
|
mykey
Old Croc Joined: 18 August 2005 Location: UK/Indonesia Status: Offline Points: 9680 |
Post Options
Thanks(0)
|
....gets coat and runs |
|
FlipC
Young Croc Joined: 25 October 2007 Status: Offline Points: 654 |
Post Options
Thanks(0)
|
Definitely interesting.
>How about a BPH aka HD15 section under the 12" section? We assume that he wants to keep the size of the porn horn to its normal size and just use unused space. I don't see why this couldn't work. The correct driver is going to be key. Estimate the amount of space you have and find the highest SPL driver that will work for the space. Subscribe |
|
tomschute
Old Croc Joined: 15 May 2006 Location: Mid Wales Status: Offline Points: 1817 |
Post Options
Thanks(0)
|
interesting project.
Looks like you know what you're doing. Chances are you'll have to have a play with tuning even if you had exact volumes if your baseing your design purely on WinISD. Get yourself a suitable mic, RTAnalysis software and some white noise going on. I would say though that a band pass for kick seems a little odd if you have horn loaded everywhere else. How about a BPH aka HD15 section under the 12" section? |
|
Out to lunch... stableaudio@hotmail.co.uk
www.stableaudio.co.uk Speaker Building Services |
|
lukam
Registered User Joined: 15 April 2009 Location: Slovenia Status: Offline Points: 46 |
Post Options
Thanks(0)
|
Hi!
I have been busy with some sketchup ideas. I'm trying to make a kick sectionin for the porn horn V2 in the box with a 15" 6th order bandpass. There would be 2 ports one above the HF horn and one under the MF horn. The front and rear chamber would be seperate between the two horns. I was planing to place the tunings around 70 and 130hz the maximal volumes availible are around 25L for the hi tuning and 65L for the low tuning. The exact volumes I don't know because I don't have the porn yet. I'm gonna use drivers from RCF or B&C. Would port turbolance affect the HF response since the port is above the horn? I know designing a 6th order BP is not gonna be easy I dont have much experiance designing 6th order BP so any help would be appreciated. I have simulated a bunch of drivers with winisd but I don't know what TS parameters to look for for a good 6th order BP. The porns would go above LABhorns so a 90hz cut max. I could also built some USBs but I want to have things in one box and as compact as possible. Here some images for better understanding Edited by lukam - 13 February 2010 at 6:36pm |
|
Post Reply | Page <12 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |