Best kick bins between X1 & MT-130 ? HD15? MTH-30? |
Post Reply | Page <123 |
Author | |
Adam_Iron_Horse
Old Croc Joined: 02 January 2010 Location: Scotland Status: Offline Points: 2043 |
Post Options
Thanks(0)
|
You would need something like a berry ultradrive to put n delay to allign the speakers
|
|
ShokZi
Registered User Joined: 05 August 2011 Status: Offline Points: 235 |
Post Options
Thanks(0)
|
isnt ultradrive 3way? i'd need a 4way xo
|
|
djyves
Young Croc Joined: 06 April 2009 Location: the Netherlands Status: Offline Points: 564 |
Post Options
Thanks(0)
|
A ultradrive has 3 inputs and 6 outputs, so If you're going four way you'll need two of them.
Or you should consider buying a DBX or so with 8 outputs.
|
|
"If brute force doesn't work, you're just not using enough!"
|
|
pfly
Old Croc Joined: 25 October 2007 Location: Helsinki, Fin Status: Offline Points: 2828 |
Post Options
Thanks(0)
|
Reasonable 8 output DSP would be Xilica XP-4080
Ultradrive would work with mono sub, mono kick and stereo midtops, that's the way I'm usually running it, its routing makes it possible, something that is not possible with DBX Driverack PA+ for example. MTH30 will probably sound quite bad doing mid/kick bass only. It is not designed for it. HD15, USB or ES18 would be the preferred ones for kick. HD15 being the smallest with smallest driver would generally be "fastest" and drop off highest, while USB is in the middle and many describe it being perhaps best sounding out of three with sufficient SPL for just about anything. In stacks it can be used without sub in most cases (excluding dub/dubstep/dnb naturally). ES18BPH is largest, drops lowest and can be used without sub, a bit like more hi-fi version of 1850 what it comes to frequency range. |
|
Adam_Iron_Horse
Old Croc Joined: 02 January 2010 Location: Scotland Status: Offline Points: 2043 |
Post Options
Thanks(0)
|
Ye I was going for mono sub and kick as there is not much point in stereo bass
|
|
KMB
Registered User Joined: 02 October 2017 Location: Belgium (dutch) Status: Offline Points: 34 |
Post Options
Thanks(0)
|
Hi guys!
Do you know some good Kick bins for x-over points 92-360hz? Its in my 4way pre amp. thanks
|
|
Keen
Young Croc Joined: 30 May 2011 Location: Brisbane, Aus Status: Offline Points: 1203 |
Post Options
Thanks(0)
|
why 360? mt130 play way lower
|
|
KMB
Registered User Joined: 02 October 2017 Location: Belgium (dutch) Status: Offline Points: 34 |
Post Options
Thanks(0)
|
Because my pre amp has crossoverpoints of 90-360hz for kick. dont think i can change it. do you know some other bins that can play untill 360hz?
|
|
Keen
Young Croc Joined: 30 May 2011 Location: Brisbane, Aus Status: Offline Points: 1203 |
Post Options
Thanks(0)
|
Letting your pe-amp determine what bins you build is backwards. Don't compromise the speakers, look at other options for xovers
|
|
Keen
Young Croc Joined: 30 May 2011 Location: Brisbane, Aus Status: Offline Points: 1203 |
Post Options
Thanks(0)
|
Or go reflex 15's for now, then have the option of putting them in horns later.
|
|
JBK
Registered User Joined: 03 March 2016 Location: Besançon Status: Offline Points: 263 |
Post Options
Thanks(0)
|
most preamp builders can change the x-over frequencies of their machine, maybe try to contact yours, otherwise some sounds take the main output of the pre and run it through a lms / xover
Edited by JBK - 24 October 2017 at 9:29am |
|
KMB
Registered User Joined: 02 October 2017 Location: Belgium (dutch) Status: Offline Points: 34 |
Post Options
Thanks(0)
|
First I will try to reset the x-overpoints of my pre amp. otherwise i will have to make 15 inch reflex bins i think.
|
|
Post Reply | Page <123 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |