1850 Cut list - A gift to you

The thing I did differently from the plans, was to lower the panel at the bottom of the chamber slightly as it seemed to be right where I wanted the bolts to go through to hold on the access panel.  I still attached it to the same corner at the front, but instead of having it go flush with the door, it went straight perpendicular from the back wall which was down about 2.5 cm from the batten edge.  Slightly increases the chamber volume, but made no difference in sim.

Interesting.  I like how you did brace 13.  I made mine the same shape as on the plan, but yours helps to support that pannel 10.  The joint between panel 9 and 10 on mine is by far the weakest joint in my build, as it is really hard to screw those two panels together from the dead space.  I suppose I could have done so before installing them, but I did not think of doing that when I was building.

Thought this might save anyone else the hassle I went through.

Uses two 2440 x 1220 x 18mm sheets. Necessary panels have the appropriate hang over accounted for to the allow for mitre angles.

Just realized I missed the access panel out but I'm sure you can work that one out for yourselves!  

Edited by Venny - 26 February 2013 at 4:41am