Schematics for Electro-Voice Zlx12-P |
Post Reply | Page <1 1516171819 32> |
Author | |
grawitserwis
New Member Joined: 05 February 2018 Location: poland Status: Offline Points: 1 |
Post Options
Thanks(0)
|
Hello Voron, can you please send me the schematics for the Electro-Voice ZLX-15P and the ZLX-12P
Greetings and thanks to polish :) My mail : grawitserwis@gmail.com |
|
MacJones
New Member Joined: 13 February 2018 Location: Liverpool Status: Offline Points: 2 |
Post Options
Thanks(0)
|
Hello Voron can you please send me the schematic for Electro Voice ZLX 12P?
many thanks Gareth gmacjones@gmail.com
|
|
Al.C.
New Member Joined: 13 February 2018 Status: Offline Points: 5 |
Post Options
Thanks(0)
|
Hello,
Voron, first I'd like to say thank you for what you're doing here. It's totally amazing, and it restores my faith in humanity. I've got a -12P and a -15P, both with problems. The amplifiers appear to be identical. The -12P has exactly the same problem that so many here have, namely burnt resistors R61-R71, and an apparently shorted Q1. The value of those components is legible on the -15P board, so I'll be fine there. The -15P has an odd problem: it's very weak in the bass. I do get clean signal through it from around 50Hz up to 12 or 14 KHz, but much quieter below about 300Hz. So guess what? Could you please send me, too, a quality copy of those schematics for diagnostic purposes? My email: albertcamus99@protonmail.com. Thank you!!! -Al C. |
|
MacJones
New Member Joined: 13 February 2018 Location: Liverpool Status: Offline Points: 2 |
Post Options
Thanks(0)
|
Many many thanks Voron for very prompt reply to my request
|
|
Al.C.
New Member Joined: 13 February 2018 Status: Offline Points: 5 |
Post Options
Thanks(0)
|
HAHAHA!
File under: "Hey, what does this button do?" File under: When in doubt, read the instructions. So I got to thinking. A clean, bass-poor signal? Well that sounds like someone just turned down the bass control... So I actually read the manual for the ZLX-15P, and the part in the "DSP" section about adjusting for an added subwoofer stood out. I put the thing back together and turned it on, and sure enough, it was set up for a bass roll-off at 120Hz to compensate for a (nonexistent) sub. Can I still charge the speakers' owners for the repair? HAHAHA! |
|
Al.C.
New Member Joined: 13 February 2018 Status: Offline Points: 5 |
Post Options
Thanks(0)
|
P.S. sorry to have bothered you Voron, and thanks again for your efforts!
|
|
voron
Registered User Joined: 05 April 2009 Location: Russia, Tver Status: Offline Points: 165 |
Post Options
Thanks(0)
|
no problem
|
|
kassie
New Member Joined: 14 February 2018 Location: RSA Status: Offline Points: 3 |
Post Options
Thanks(0)
|
Hi Veron, please can you send me the schematics for Electro Voice ZLX 12P?
The power supply is pulsing - I assume a shorted part in amp or pre amp. my email is. kaspaas.one@gmail.com Much appreciated. Br Kassie
|
|
kassie
New Member Joined: 14 February 2018 Location: RSA Status: Offline Points: 3 |
Post Options
Thanks(0)
|
Thanks Vonon, received.
Much appreciated
Kind Regards Kassie |
|
kassie
New Member Joined: 14 February 2018 Location: RSA Status: Offline Points: 3 |
Post Options
Thanks(0)
|
Morning Voron,
Are there any power supply schematics for Electro Voice ZLX 12P?
Please can you also send me the power supply schematics if available? my email is. kaspaas.one@gmail.com Much appreciated. Br Kassie |
|
Al.C.
New Member Joined: 13 February 2018 Status: Offline Points: 5 |
Post Options
Thanks(0)
|
Hi Voron,
Me again... I've rebuilt that resistor array (R61-71), and replaced Q1, but still no go. Now I suspect Q2, which will be hard to find... But without a scvhematic I can't be sure of anythhing much. Would you be so kind as to send me the power board schematic too? THANK YOU! albertcamus99@protonmail.com |
|
Al.C.
New Member Joined: 13 February 2018 Status: Offline Points: 5 |
Post Options
Thanks(0)
|
большое спасибо! |
|
Post Reply | Page <1 1516171819 32> |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |