Speakerplans.com Homepage
Forum Home Forum Home > General > Electro Frying Forum
  New Posts New Posts RSS Feed - tweeter wiring
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

tweeter wiring

 Post Reply Post Reply
Author
Message
Daganjah View Drop Down
Registered User
Registered User


Joined: 29 June 2020
Status: Offline
Points: 15
Post Options Post Options   Thanks (0) Thanks(0)   Quote Daganjah Quote  Post ReplyReply Direct Link To This Post Topic: tweeter wiring
    Posted: 01 July 2021 at 2:19pm
hello everyone
im building a mid top speaker with
1 12״ woofer 8ohm
1 2״ tweeter 8ohm
2 super tweeters 8ohm with a passive crossover

i want to know what would be the best way to connect the tweeters to my amp
(i use a separate amp for the 12״ woofer)

thank you!


Back to Top
Conanski View Drop Down
Old Croc
Old Croc
Avatar

Joined: 26 January 2006
Location: Ottawa, Canada
Status: Offline
Points: 2515
Post Options Post Options   Thanks (0) Thanks(0)   Quote Conanski Quote  Post ReplyReply Direct Link To This Post Posted: 01 July 2021 at 3:07pm
With speaker cable same as you do for the 12". 
I suspect there is more to this inquiry that you have not articulated but I'm not going to guess
Back to Top
Daganjah View Drop Down
Registered User
Registered User


Joined: 29 June 2020
Status: Offline
Points: 15
Post Options Post Options   Thanks (0) Thanks(0)   Quote Daganjah Quote  Post ReplyReply Direct Link To This Post Posted: 01 July 2021 at 3:30pm
thank you fro the quick answer
i think i wasn't clear enough 
i meant to ask what would be the best wiring for 1 amp channel?
do i connect them in parallel or in series?       

Back to Top
Conanski View Drop Down
Old Croc
Old Croc
Avatar

Joined: 26 January 2006
Location: Ottawa, Canada
Status: Offline
Points: 2515
Post Options Post Options   Thanks (0) Thanks(0)   Quote Conanski Quote  Post ReplyReply Direct Link To This Post Posted: 01 July 2021 at 7:28pm
What are you using as a crossover between the 12 and CD?

So all 3 high frequency drivers on 1 channel right.. easy enough. 
You said you were going to use a passive crossover for those so it will split the signal into low and high outputs, low goes to the CD and high to the bullets. The bullets could be wired in series or parallel just depends if you need more or less output from them, and what impedance the crossover is designed for. 
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.078 seconds.