Multicell horn |
Post Reply |
Author | |
kgthedj
New Member Joined: 13 April 2009 Location: NYC Status: Offline Points: 6 |
Post Options
Thanks(0)
Posted: 06 September 2022 at 3:06pm |
This is a multicell horn prototype, 3d printed in PLA tough.
Shout out to https://www.thingiverse.com/pelanj - pelanj over on
thingiverse. I am using the DS18 PRO-D1 2" Throat Bolt On Compression Driver. k https://youtube.com/shorts/hgM2tsE4JSM?feature=share Edited by kgthedj - 08 September 2022 at 9:16pm |
|
kgthedj
New Member Joined: 13 April 2009 Location: NYC Status: Offline Points: 6 |
Post Options
Thanks(0)
|
just figure out how to post pictures lol
Edited by kgthedj - 08 September 2022 at 9:22pm |
|
teeth
Young Croc Joined: 05 July 2021 Status: Offline Points: 561 |
Post Options
Thanks(1)
|
that's wicked. i now want to make one :)
|
|
teeth
Young Croc Joined: 05 July 2021 Status: Offline Points: 561 |
Post Options
Thanks(0)
|
how does it sound though!?
|
|
VECTORDJ
Young Croc Joined: 11 June 2006 Location: United States Status: Offline Points: 513 |
Post Options
Thanks(0)
|
A 511B or 811B Altec Horn 3d Printed???????
|
|
teeth
Young Croc Joined: 05 July 2021 Status: Offline Points: 561 |
Post Options
Thanks(0)
|
@kgthedj how much did this cost to print in total? |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |