Carlsbro Showman |
Post Reply |
Author | |
kedwardsleisure
Old Croc Joined: 20 January 2009 Location: Staffordshire Status: Offline Points: 4949 |
Post Options
Thanks(0)
Posted: 30 March 2011 at 10:19pm |
Hullo, Im after a diagram for a Carlsbro Showman S800 or similar, cheers Kevin
|
|
Kevin
North Staffordshire |
|
Mark vincent
Registered User Joined: 07 August 2020 Location: Exeter Status: Offline Points: 15 |
Post Options
Thanks(0)
|
Did you have any luck with the showman diagram as I have one with a fault? Thanks mark
|
|
kedwardsleisure
Old Croc Joined: 20 January 2009 Location: Staffordshire Status: Offline Points: 4949 |
Post Options
Thanks(0)
|
Crikey, 9 years ago! Yes, I sorted it, but can't remember if I found a diagram. If I did it will be in a folder somewhere.
I don't remember alot about it, other than I think it had 'special' part numbered transistors and those curious oxide-coated heatsinks that don't need an insulating washer in order to keep insulated. |
|
Kevin
North Staffordshire |
|
Mark vincent
Registered User Joined: 07 August 2020 Location: Exeter Status: Offline Points: 15 |
Post Options
Thanks(0)
|
I have one where both channels are working but on the parametric pots the -20-+20 feeds back when it’s turned above a 1/3 of the way up I’ve cleaned the pot still the same any ideas thanks mark
|
|
kedwardsleisure
Old Croc Joined: 20 January 2009 Location: Staffordshire Status: Offline Points: 4949 |
Post Options
Thanks(0)
|
if its an active filter circuit it wont be feeding back I dont suppose, it's probably bursting into oscillation. I'd have thought it was a pretty simple circuit, maybe based around an op-amp. Make doubly-sure the pot is ok and properly soldered before getting into the electronics, or it might have a dead spot.
|
|
Kevin
North Staffordshire |
|
Mark vincent
Registered User Joined: 07 August 2020 Location: Exeter Status: Offline Points: 15 |
Post Options
Thanks(0)
|
I’m in Exeter is there anyone that can fix it I did notice that there are 4 quite big resistors that get very hot in a matter of minutes thanks mark
|
|
t16coupe
New Member Joined: 03 June 2014 Status: Offline Points: 8 |
Post Options
Thanks(0)
|
i have one i think the inputs need repairing as you have to plug your soruce in though the mic input to get sound
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |