Ecler Amps working at 16 Ohm loads? |
Post Reply |
Author | |
needle fx
Registered User Joined: 04 May 2009 Location: UK Status: Offline Points: 39 |
Post Options
Thanks(0)
Posted: 11 March 2012 at 7:07pm |
Hi everyone. I have being looking around i even try emailing the people at ecler with no success :( Can anyone tell me if the ecler amplifiers from the series APA and DPA can be used at 16 ohms? Thanks for any info.
|
|
audiomik
Old Croc Joined: 06 April 2010 Location: Bath, UK Status: Offline Points: 2962 |
Post Options
Thanks(0)
|
Should be absolutely no reason why they wont!
All other Amplifiers do, unless designed and built specifically for 70 or 100 Volt line outputs. Although setting the output impedance for Valve Amplifiers is quite important, but even they then drive 16 ohm loads happily....... Mik |
|
Warning! May contain Nuts
plus springs, washers, screws, etc, etc. |
|
Mircea Bartic
Old Croc Joined: 18 February 2005 Location: Romania Status: Offline Points: 2581 |
Post Options
Thanks(0)
|
Absolutely no problem with 16 ohm loads
we are Dealers in Romania for ECLER |
|
general manager & head designer at nexus-acoustics research
http://www.facebook.com/nexus.acoustics.research Ex Nexus_3 |
|
needle fx
Registered User Joined: 04 May 2009 Location: UK Status: Offline Points: 39 |
Post Options
Thanks(0)
|
Thank you both!! Big help!!
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |