Speakerplans.com Homepage
Forum Home Forum Home > General > Amp Forum
  New Posts New Posts RSS Feed - crown xti password
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

crown xti password

 Post Reply Post Reply
Author
Message
splodge360 View Drop Down
Registered User
Registered User
Avatar

Joined: 15 September 2007
Location: East London
Status: Offline
Points: 88
Post Options Post Options   Thanks (0) Thanks(0)   Quote splodge360 Quote  Post ReplyReply Direct Link To This Post Topic: crown xti password
    Posted: 12 August 2012 at 12:46am
recently had "keypad locked" come up on one of the displays of my crown xti4000 power amps.  Tried turning on with up/ down pressed at the sametime, but that hasnt cleared it.
have put it under Harmans "bandmager" usb software to remote programme, but says it needs update through "system architect" software, connected to that, but to do a factory reset/ software update etc need to enter the password for that amp.
tried the serial number off the back, 4000 and other combos but havent cracked it yet.
Anyone know, or can i just remove a battery back up from inside, to clear settings.
frustrating cos otherwise all works well,. just cant change dsp settings
LineArrayHire

Back to Top
atomicmist View Drop Down
New Member
New Member


Joined: 05 October 2009
Location: Canada
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote atomicmist Quote  Post ReplyReply Direct Link To This Post Posted: 12 August 2012 at 1:54am
Did you try holding the two right buttons down for about 6 seconds?
It should unlock after that. There is also a procedure to do a factory reset but your programming will be lost. Let me know if you need the procedure and I'll PM it to you.


Edited by atomicmist - 12 August 2012 at 1:55am
Back to Top
atomicmist View Drop Down
New Member
New Member


Joined: 05 October 2009
Location: Canada
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote atomicmist Quote  Post ReplyReply Direct Link To This Post Posted: 12 August 2012 at 2:03am
Straight from Crown's support forum:
 
http://www.crownaudio.com/forums/index.php?showtopic=3860 - http://www.crownaudio.com/forums/index.php?showtopic=3860
Back to Top
kedwardsleisure View Drop Down
Old Croc
Old Croc


Joined: 20 January 2009
Location: Staffordshire
Status: Offline
Points: 4938
Post Options Post Options   Thanks (0) Thanks(0)   Quote kedwardsleisure Quote  Post ReplyReply Direct Link To This Post Posted: 18 March 2021 at 9:27am
if you force a firmware update in HiQnet it should clear everything
Kevin

North Staffordshire

Back to Top
M4trix View Drop Down
Registered User
Registered User
Avatar

Joined: 23 June 2009
Location: Croatia
Status: Offline
Points: 445
Post Options Post Options   Thanks (0) Thanks(0)   Quote M4trix Quote  Post ReplyReply Direct Link To This Post Posted: 18 March 2021 at 6:15pm
Good old times when you didn't need a password for amps. Well, this is what you get when new kids are on the block. Ouch


Edited by M4trix - 18 March 2021 at 6:16pm
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.109 seconds.