MT102 Construction |
Post Reply |
Author | |
Andrew
Registered User Joined: 10 March 2004 Location: United Kingdom Status: Offline Points: 669 |
Post Options
Thanks(0)
Posted: 27 October 2004 at 5:46pm |
Does anyone know how the slopnig sides of the MT102 are supposed to work? Does one cut down one edge of the timber to a paper-thin edge, or does it start 60mm at the driver end, and finish at 18mm (the timber thickness) at the cabinet base, and the same by the middle section? |
|
Dom
Old Croc Joined: 25 February 2004 Location: United Kingdom Status: Offline Points: 1700 |
Post Options
Thanks(0)
|
I'd cut it with a 9.5 degree mitre on the end that meets the baffle and a 80.5 degree mitre on the end at the front of the cab. Same angle, you just have to hold the piece at 90 degrees to the saw when you cut the 80.5 degree angle...
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |