6mm wood inserts |
Post Reply |
Author | |
IainB
Registered User Joined: 25 November 2016 Location: Rushden Status: Offline Points: 422 |
Post Options
Thanks(0)
Posted: 19 May 2017 at 10:49pm |
Tonights stupid question!
Im using 6mm wood inserts, as these are screwed in, im assuming they are fitted on the speaker side rather than the opposite side as you would a pronged T nut? Otherwise if they were installed the same side as a T Nut tightening the speaker has the potential to unscrew the insert (I really shouldnt post after a drink)
|
|
odc04r
Old Croc Joined: 12 July 2006 Location: Sarfampton Status: Offline Points: 5482 |
Post Options
Thanks(0)
|
Might be reverse threaded, if so same insert side as bolt and they will both tighten together. Should be obvious looking at them
|
|
IainB
Registered User Joined: 25 November 2016 Location: Rushden Status: Offline Points: 422 |
Post Options
Thanks(0)
|
Havent even checked that yet to be honest (they are still in the packet!), it just popped into my head as im dry building the first box tomorrow and the cubo kick has a baffle over half the speaker opening so was planning how to attach everything in my head and on multiple bits of paper!
On the upside, reasonably happy with my cuts earlier, so thats a good start Edit - checked, these dont appear to be a reverse thread, so will be going speaker side (ever wish you could delete a post?)
Edited by IainB - 19 May 2017 at 11:40pm |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |