Martin Mac 250+ Failed |
Post Reply |
Author | |
Fatinator
Registered User Joined: 10 November 2014 Location: Sweden Status: Offline Points: 12 |
Post Options
Thanks(0)
Posted: 25 June 2017 at 4:39pm |
Hello!
I have a Martin Mac 250+ with a problem to drive the prism lens on and off. The servo/stepper that moves(not the rotating, that one works perfectly) the prism lens up and down seems to fail occasionally. Sometimes it gets stuck in on or off mode, motor just ticks/moves 1mm then stops. I have tried changing complete prism motor-module with another working Mac 250+ with zero success.. So the prism motors seems to be no problem, something about the motor driver might be faulty. I have no idea how to change that part so i would need a little step-by-step guide for it. Any ideas, experiences or something? Just shoot! Best Regards, Fatinator
|
|
simonp1100
Young Croc Joined: 01 September 2008 Location: Bristol Status: Offline Points: 1103 |
Post Options
Thanks(0)
|
Classic wire loom fault, change both the prism wire sets & this will solve the problem.
|
|
Fatinator
Registered User Joined: 10 November 2014 Location: Sweden Status: Offline Points: 12 |
Post Options
Thanks(0)
|
Alright,
Do you have part no. and any recommended place to buy theese wires?
|
|
simonp1100
Young Croc Joined: 01 September 2008 Location: Bristol Status: Offline Points: 1103 |
Post Options
Thanks(0)
|
You just need to find your local Martin dealer and get it through him, i have no part numbers or price I'm afraid. |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |