General Forum - Ta 2400 Help!

Print Page | Close Window

Ta 2400 Help!

Printed From: Speakerplans.com
Category: General
Forum Name: General Forum
Forum Description: Open Discussion / Questions
URL: https://forum.speakerplans.com/forum_posts.asp?TID=107122
Printed Date: 22 September 2023 at 3:13pm
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com

Topic: Ta 2400 Help!

Posted By: BeAnTeK
Subject: Ta 2400 Help!
Date Posted: 31 May 2022 at 1:34am

Hi there just tryna figure out how to run my void v18 1000

On my ya 2400 in bridge mode am unsure what I need to switch and/or re-wire. Any help would be greatly appreciated.

Many thanks

Replies:

Posted By: BeAnTeK
Date Posted: 31 May 2022 at 1:59am

Also would running this amp in bridge mode be okay for this driver as at 8 ohm it chugs out 2300watts just don’t wanna cook anything.

Posted By: BigSoundNorthWest
Date Posted: 14 June 2022 at 7:56am

You'll need to switch it to bridge mode first,

Then, input into channel A.

Output. Pin 1+ is 1+ (red post) on Ch A

Pin 1- is 1 - (red post) on Ch B.

Posted By: BigSoundNorthWest
Date Posted: 14 June 2022 at 7:58am

Yes as long as you watch the input signal for getting too high, you should have miles of headroom for the driver.