Rj45 in a xlr type body.
Printed From: Speakerplans.com
Category: General
Forum Name: General Forum
Forum Description: Open Discussion / Questions
URL: https://forum.speakerplans.com/forum_posts.asp?TID=107526
Printed Date: 22 March 2023 at 3:31pm
Software Version: Web Wiz Forums 12.05 - http://www.webwizforums.com
Topic: Rj45 in a xlr type body.
Posted By: kevin tyler
Subject: Rj45 in a xlr type body.
Date Posted: 03 December 2022 at 3:23pm
|
Hi guys Hope all are well, when you mount an existing lan cable in one of these plugs, do you have to snip the latch off the plug ? Many thanks Kev https://www.thomann.de/es/neutrik_ne8mx_b.htm" rel="nofollow - https://www.thomann.de/es/neutrik_ne8mx_b.htm |
Replies:
Posted By: toastyghost
Date Posted: 03 December 2022 at 4:34pm
|
No, there’s a cutout for it that you can see in the photos there. The connection should still latch. The relevant EtherCon socket on the other end should release the latching tab on the RJ45 connector when the push tab on the socket is pressed. If you’re making a new cable and termination to go in the EtherCon connector, then it’s good practice to tie the drain of the CAT cable to the outer ring of the EtherCon. That should ensure a shielded connection; commonly mixing desks such as the Behringer X32 won’t have a shielded connection to their digital stage boxes if this isn’t done. |
Posted By: BJtheDJ
Date Posted: 03 December 2022 at 6:10pm
Same Page but in English http://www.thomann.de/gb/neutrik_ne8mx_b.htm" rel="nofollow - If your vaccinations were mandatory and nobody in your class had measles, then you know that you're not a Millenial kid.</f |
kevin tyler wrote:Posted By: kevin tyler
Date Posted: 04 December 2022 at 2:52pm
|
Thanks toasty ghost, it’s only the lan cable from my router to the berry x air, Cheers.
|