Print Page | Close Window

Problem with the plan.

Printed From:
Category: Plans
Forum Name: 1850 and 186 horns
Forum Description: Discussion / Questions about the 1850 and 186 horns
Printed Date: 30 March 2023 at 7:21pm
Software Version: Web Wiz Forums 12.05 -

Topic: Problem with the plan.
Posted By: AM55
Subject: Problem with the plan.
Date Posted: 21 December 2010 at 11:39pm

I'm trying to CAD up the 1850 horn and am having a problem with the baffle. If I draw the baffle in and then set it to the correct angle as per the plans it does not match up to the measurements on the other side again as per the plans. Hopefully you will see what I mean in the picture below.">

The solution is probably staring my in the face but I just cant see it.

Posted By: hmaudio
Date Posted: 21 December 2010 at 11:54pm
how much is it off by? 

Nottingham based cab builder.
This account is used by 2 people.

Posted By: AM55
Date Posted: 22 December 2010 at 12:08am
18mm. I could just extend the other panel up but thats not the point, I cant see why I cant translate from the plan to my computer.

Posted By: cravings
Date Posted: 22 December 2010 at 12:49am
if the wood is 18mm thick in your cad drawing.. then the piece on the right of the picture (access panel / surround in the original plan) doesn't look 18mm thick at all.. that would affect it a bit..

Posted By: Centauri
Date Posted: 22 December 2010 at 1:52am
The cabinet depth is 750mm to the outside of the rear panel, so depth from front to inside of rear panel will be 18mm shorter - did you account for that?  Calculating it out, the 190 dimension is probably closer to 189.2mm

Posted By: AM55
Date Posted: 22 December 2010 at 8:27am
Originally posted by Centauri Centauri wrote:

The cabinet depth is 750mm to the outside of the rear panel

This is my problem, I have taken 750 to the inside of the rear panel. Thank you!

Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.05 -
Copyright ©2001-2022 Web Wiz Ltd. -