Martin Mac 250+ Failed
Printed From: Speakerplans.com
Category: Other Chat
Forum Name: Lighting Talk
Forum Description: All your lampy, laser and 'other' special FX needs....
URL: https://forum.speakerplans.com/forum_posts.asp?TID=98775
Printed Date: 19 April 2024 at 4:47am
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: Martin Mac 250+ Failed
Posted By: Fatinator
Subject: Martin Mac 250+ Failed
Date Posted: 25 June 2017 at 4:39pm
|
Hello! I have a Martin Mac 250+ with a problem to drive the prism lens on and off. The servo/stepper that moves(not the rotating, that one works perfectly) the prism lens up and down seems to fail occasionally. Sometimes it gets stuck in on or off mode, motor just ticks/moves 1mm then stops. I have tried changing complete prism motor-module with another working Mac 250+ with zero success.. So the prism motors seems to be no problem, something about the motor driver might be faulty. I have no idea how to change that part so i would need a little step-by-step guide for it. Any ideas, experiences or something? Just shoot! Best Regards, Fatinator
|
Replies:
Posted By: simonp1100
Date Posted: 26 June 2017 at 6:04am
Classic wire loom fault, change both the prism wire sets & this will solve the problem. |
Posted By: Fatinator
Date Posted: 26 June 2017 at 4:12pm
|
Alright, Do you have part no. and any recommended place to buy theese wires?
|
Posted By: simonp1100
Date Posted: 01 July 2017 at 7:13am
You just need to find your local Martin dealer and get it through him, i have no part numbers or price I'm afraid. |
Fatinator wrote: