|
db mark bits |
Post Reply 
|
Page 123> |
| Author | |
teeth 
Young Croc 
Joined: 05 July 2021 Status: Offline Points: 762 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: db mark bitsPosted: 14 December 2021 at 10:30am |
|
is someone able to give a run down of the different db mark models?
i think it's time to upgrade my ultradrive, but not sure which to get. other than the inputs / outputs, i'm not sure what the difference between the XCA and DP series, though i'm sure either will be a decent upgrade on the berry!
|
|
 |
|
|
richardwatts87
Registered User 
Joined: 22 November 2021 Location: Leeds Status: Offline Points: 21 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 December 2021 at 12:16pm |
|
I recently upgraded from an ultra drive to a 2 in 6 out xca. Not used it a shed load yet, but first impressions are:
- Better sound quality - Intuitive and easy to use program on PC, I also found it alot easier to connect to. - Display on unit isn't quite as easy to navigate and use as the ultra drive. Easy enough mind, and I mostly use my pc anyway - I like the mute buttons assigned to each channel. Thumbs up over all....
|
|
|
|
|
shaun1264
Registered User
Joined: 06 September 2013 Location: Surrey Status: Offline Points: 325 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 December 2021 at 1:12pm |
|
XCAs seems to be well built, decent sound quality with some good A/D D/A chips and opamps. It has a traditional linear power supply .
|
|
|
|
|
paulus
Old Croc 
Joined: 14 December 2005 Location: SOUTH BIRMINGHA Status: Offline Points: 3237 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 December 2021 at 2:01pm |
|
not a hi jack but i have one for sale 4 in 8 dp48 out of an install no box but mint , never been on road 250 plus post if anyone interested, pm me 440 new
|
|
|
TRENDSETTER SOUND SYSTEM
|
|
|
|
|
tomrotten
Registered User
Joined: 10 June 2019 Location: London Status: Offline Points: 33 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 December 2021 at 7:15am |
|
PM'd
|
|
|
rotten noise soundsystem
1850s - A.S.S - FFA |
|
|
|
|
teeth
Young Croc
Joined: 05 July 2021 Status: Offline Points: 762 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 December 2021 at 1:24pm |
|
ah will take that please!
|
|
|
|
|
shaun1264
Registered User
Joined: 06 September 2013 Location: Surrey Status: Offline Points: 325 |
Post Options
Thanks(0)
Quote Reply
Posted: 26 December 2021 at 9:07am |
|
Not long after posting on this subject my DB Mark XCA has started playing up. One channel seems slightly lower in volume than the other. I've narrowed it down to the input section . Swapping back to a JBL DSC260 both inputs are dead on equal. So definitely the XCA.
|
|
|
|
|
teeth
Young Croc
Joined: 05 July 2021 Status: Offline Points: 762 |
Post Options
Thanks(0)
Quote Reply
Posted: 27 December 2021 at 12:18pm |
|
you reckon that's a settings thing or there's an actual problem with the unit?
|
|
|
|
|
toastyghost
The 10,000 Points Club 
Joined: 09 January 2007 Location: Manchester Status: Offline Points: 10932 |
Post Options
Thanks(0)
Quote Reply
Posted: 27 December 2021 at 3:06pm |
The easiest way to test that is to perform a factory reset or firmware flash on the device. You can also verify the output difference by simply connecting a volt meter to the output channels. |
|
|
|
|
shaun1264
Registered User
Joined: 06 September 2013 Location: Surrey Status: Offline Points: 325 |
Post Options
Thanks(0)
Quote Reply
Posted: 01 January 2022 at 8:14am |
|
Update on this. I fixed it. The issue was a dry joint, high resistance joint to the input op-amp. Everything else was fine on the board. Not sure why it happened.
These active crossovers are built well, solid construction and decent chips. It's unusual that it has a linear power supply (transformer, full bridge rectifier and voltage regulators) The only slight concern would be the cheap capacitors but that is the same to alot of modern products these days.
|
|
|
|
|
teeth
Young Croc
Joined: 05 July 2021 Status: Offline Points: 762 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 January 2022 at 9:01pm |
|
well, i got a DP28+ my initial thoughts: i interface isn't as bad as i remembered behringer is still better (mainly due to the screen) dear god that screen is BRIGHT (can it be turned down?) decent features i like the AGC on inputs, i was going to get a AVC (formula sound) but will so how i go with this yet to comment on sound as i have yet to make some sound with it no spaces or special characters when saving presets. weird no manual, can't find one online anywhere. it's pretty self explanatory, but i love reading manuals... anyone seen one?
|
|
|
|
|
angus
Young Croc
Joined: 10 August 2005 Location: TW, Kent, UK Status: Offline Points: 516 |
Post Options
Thanks(0)
Quote Reply
Posted: 25 June 2022 at 8:55pm |
|
I know it's a bit late but I found this if you're still interested https://dbmark.co.uk/content/downloads/DP+manual.pdf
(I was searching for advice and info on alternatives or options relating to the classic AVC limiter and this thread popped up in search.) |
|
|
They're complaining over there, but it's their fault!
|
|
|
|
|
Post Reply
|
Page 123> |
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
teeth wrote: