|
MT 122 BACK PANEL |
Post Reply 
|
| Author | |
MIKEY SOUL 
Registered User 
Joined: 27 October 2004 Status: Offline Points: 230 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: MT 122 BACK PANELPosted: 27 October 2004 at 12:29am |
|
I looked at the top view of the removable back panel and noticed that the widest dimension is on the side that is facing the inside of the MT 122. As the exterior sides of the box is tapered how can one assemble the back panel as per drawing? I also note no cleats (battens) adjacent to the back panel. |
|
 |
|
|
Fushion Julz
Registered User
Joined: 19 August 2004 Status: Offline Points: 647 |
Post Options
Thanks(0)
Quote Reply
Posted: 27 October 2004 at 10:11am |
|
My Mt 122s have a back panel that is full length and fit the outside dimension...otherwise you couldn't get them in! I used battens around the top, bottom and sides of each rear chamber and the dividing shelf is also a "batten" to which the back panel is screwed. To ensure a good air-tight fit I use a silicon sealer (bath seal) around all the joints.
|
|
|
|
|
MIKEY SOUL
Registered User
Joined: 27 October 2004 Status: Offline Points: 230 |
Post Options
Thanks(0)
Quote Reply
Posted: 27 October 2004 at 12:14pm |
|
Hey Julz: Much thanks. The drawings need to be amended.
|
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options